/*
typedef unsigned int UINT32;
typedef signed int INT32;
typedef unsigned short UINT16;
typedef signed short INT16;
typedef unsigned char UINT8;
typedef signed char INT8;
*/
typedef INT16 stream_sample_t;
typedef stream_sample_t FMSAMPLE;
#ifndef EMUL2203_H
#define EMUL2203_H
/* select bit size of output : 8 or 16 */
#define FM_SAMPLE_BITS 16
/* select timer system internal or external */
#define FM_INTERNAL_TIMER 0
/* --- speedup optimize --- */
/* busy flag enulation , The definition of FM_GET_TIME_NOW() is necessary. */
#define FM_BUSY_FLAG_SUPPORT 1
/* struct describing a single operator (SLOT) */
typedef struct
{
INT32 *DT; /* detune :dt_tab[DT] */
UINT8 KSR; /* key scale rate :3-KSR */
UINT32 ar; /* attack rate */
UINT32 d1r; /* decay rate */
UINT32 d2r; /* sustain rate */
UINT32 rr; /* release rate */
UINT8 ksr; /* key scale rate :kcode>>(3-KSR) */
UINT32 mul; /* multiple :ML_TABLE[ML] */
/* Phase Generator */
UINT32 phase; /* phase counter */
UINT32 Incr; /* phase step */
/* Envelope Generator */
UINT8 state; /* phase type */
UINT32 tl; /* total level: TL << 3 */
INT32 volume; /* envelope counter */
UINT32 sl; /* sustain level:sl_table[SL] */
UINT32 vol_out; /* current output from EG circuit (without AM from LFO) */
UINT8 eg_sh_ar; /* (attack state) */
UINT8 eg_sel_ar; /* (attack state) */
UINT8 eg_sh_d1r; /* (decay state) */
UINT8 eg_sel_d1r; /* (decay state) */
UINT8 eg_sh_d2r; /* (sustain state) */
UINT8 eg_sel_d2r; /* (sustain state) */
UINT8 eg_sh_rr; /* (release state) */
UINT8 eg_sel_rr; /* (release state) */
UINT8 ssg; /* SSG-EG waveform */
UINT8 ssgn; /* SSG-EG negated output */
UINT32 key; /* 0=last key was KEY OFF, 1=KEY ON */
} FM_SLOT;
typedef struct
{
FM_SLOT SLOT[4]; /* four SLOTs (operators) */
UINT8 ALGO; /* algorithm */
UINT8 FB; /* feedback shift */
INT32 op1_out[2]; /* op1 output for feedback */
INT32 *connect1; /* SLOT1 output pointer */
INT32 *connect2; /* SLOT2 output pointer */
INT32 *connect3; /* SLOT3 output pointer */
INT32 *connect4; /* SLOT4 output pointer */
INT32 *mem_connect;/* where to put the delayed sample (MEM) */
INT32 mem_value; /* delayed sample (MEM) value */
INT32 pms; /* channel PMS */
UINT8 ams; /* channel AMS */
UINT32 fc; /* fnum,blk:adjusted to sample rate */
UINT8 kcode; /* key code: */
UINT32 block_fnum; /* current blk/fnum value for this slot (can be different betweeen slots of one channel in 3slot mode) */
} FM_CH;
typedef struct
{
void * param; /* this chip parameter */
int clock; /* master clock (Hz) */
int SSGclock; /* clock for SSG (Hz) */
int rate; /* sampling rate (Hz) */
double freqbase; /* frequency base */
double TimerBase; /* Timer base time */
#if FM_BUSY_FLAG_SUPPORT
double BusyExpire; /* ExpireTime of Busy clear */
#endif
UINT8 address; /* address register */
UINT8 irq; /* interrupt level */
UINT8 irqmask; /* irq mask */
UINT8 status; /* status flag */
UINT32 mode; /* mode CSM / 3SLOT */
UINT8 prescaler_sel;/* prescaler selector */
UINT8 fn_h; /* freq latch */
int TA; /* timer a */
int TAC; /* timer a counter */
UINT8 TB; /* timer b */
int TBC; /* timer b counter */
/* local time tables */
INT32 dt_tab[8][32];/* DeTune table */
/* Extention Timer and IRQ handler */
// FM_TIMERHANDLER Timer_Handler;
// FM_IRQHANDLER IRQ_Handler;
// const struct ssg_callbacks *SSG;
} FM_ST;
/***********************************************************/
/* OPN unit */
/***********************************************************/
/* OPN 3slot struct */
typedef struct
{
UINT32 fc[3]; /* fnum3,blk3: calculated */
UINT8 fn_h; /* freq3 latch */
UINT8 kcode[3]; /* key code */
UINT32 block_fnum[3]; /* current fnum value for this slot (can be different betweeen slots of one channel in 3slot mode) */
} FM_3SLOT;
/* OPN/A/B common state */
typedef struct
{
UINT8 type; /* chip type */
FM_ST ST; /* general state */
FM_3SLOT SL3; /* 3 slot mode state */
FM_CH *P_CH; /* pointer of CH */
UINT32 eg_cnt; /* global envelope generator counter */
UINT32 eg_timer; /* global envelope generator counter works at frequency = chipclock/64/3 */
UINT32 eg_timer_add; /* step of eg_timer */
UINT32 eg_timer_overflow;/* envelope generator timer overlfows every 3 samples (on real chip) */
/* there are 2048 FNUMs that can be generated using FNUM/BLK registers
but LFO works with one more bit of a precision so we really need 4096 elements */
UINT32 fn_table[2048]; /* fnumber->increment counter */
} FM_OPN;
/* here's the virtual YM2203(OPN) */
typedef struct
{
UINT8 REGS[256]; /* registers */
FM_OPN OPN; /* OPN state */
FM_CH CH[3]; /* channel state */
} YM2203;
#define FM_GET_TIME_NOW() 0
//timer_get_time()
#ifndef PI
#define PI 3.14159265358979323846
#endif
/* -------------------- YM2203(OPN) Interface -------------------- */
/*
** Initialize YM2203 emulator(s).
**
** 'num' is the number of virtual YM2203's to allocate
** 'baseclock'
** 'rate' is sampling rate
** 'TimerHandler' timer callback handler when timer start and clear
** 'IRQHandler' IRQ callback handler when changed IRQ level
** return 0 = success
*/
void * YM2203Init(void *param, int index, int baseclock, int rate
// ,FM_TIMERHANDLER TimerHandler,FM_IRQHANDLER IRQHandler, const struct ssg_callbacks *ssg
);
/*
** shutdown the YM2203 emulators
*/
void YM2203Shutdown(void *chip);
/*
** reset all chip registers for YM2203 number 'num'
*/
void YM2203ResetChip(void *chip);
/*
** update one of chip
*/
void YM2203UpdateOne(void *chip, FMSAMPLE *buffer, int length);
/*
** Write
** return : InterruptLevel
*/
int YM2203Write(void *chip,int a,unsigned char v);
/*
** Read
** return : InterruptLevel
*/
unsigned char YM2203Read(void *chip,int a);
/*
** Timer OverFlow
*/
int YM2203TimerOver(void *chip, int c);
/*
** State Save
*/
void YM2203Postload(void *chip);
void YM2203_save_state(void *chip, int index);
void OPNPrescaler_w(FM_OPN *OPN , int addr, int pre_divider);
#endif