Top secrets sources NedoPC pentevo

                ifndef  __stm8sadc2inc  ; avoid multiple inclusion
__stm8sadc2inc  equ     1

                save
                listing off             ; no listing over this file

;****************************************************************************
;*                                                                          *
;*   AS 1.42 - File ADC2.INC                                                *
;*                                                                          *
;*   contains SFR and Bit Definitions for STM8S ADC2                        *
;*                                                                          *
;****************************************************************************

__defadc2       macro   NAME,BUFBASE,Base
__NS            set     "\{NAME}_"
                if      "BUFBASE"<>""
{__NS}DB0R      label   BUFBASE         ; ADC data buffer registers
{__NS}DB1R      label   BUFBASE+1
{__NS}DB2R      label   BUFBASE+2
{__NS}DB3R      label   BUFBASE+3
                endif
{__NS}CSR       label   Base+$00        ; ADC control/status register
{__NS}EOC       bit     {__NS}CSR,7     ;  End of conversion
{__NS}AWD       bit     {__NS}CSR,6     ;  Analog Watchdog flag
{__NS}EOCIE     bit     {__NS}CSR,5     ;  Interrupt enable for EOC
{__NS}AWDIE     bit     {__NS}CSR,4     ;  Analog watchdog interrupt enable
{__NS}CH        bfield  {__NS}CSR,0,4   ;  Channel selection bits
{__NS}CR1       label   Base+$01        ; ADC configuration register 1
{__NS}SPSEL     bfield  {__NS}CR1,4,3   ;  Prescaler selection
{__NS}CONT      bit     {__NS}CR1,1     ;  Continuous conversion
{__NS}ADON      bit     {__NS}CR1,0     ;  A/D Converter on/off
{__NS}CR2       label   Base+$02        ; ADC configuration register 2
{__NS}EXTTRIG   bit     {__NS}CR2,6     ;  External trigger enable
{__NS}EXTSEL    bfield  {__NS}CR2,4,2   ;  External event selection
{__NS}ALIGN     bit     {__NS}CR2,3     ;  Data alignment
{__NS}SCAN      bit     {__NS}CR2,1     ;  Scan mode enable
{__NS}CR3       label   Base+$03        ; ADC configuration register 3
{__NS}DBUF      bit     {__NS}CR3,7     ;  Data buffer enable
{__NS}OVR       bit     {__NS}CR3,6     ;  Overrun flag
{__NS}DRH       label   Base+$04        ; ADC data register high
{__NS}DRL       label   Base+$05        ; ADC data register low
{__NS}TDRH      label   Base+$06        ; ADC Schmitt trigger disable register high
{__NS}TDRL      label   Base+$07        ; ADC Schmitt trigger disable register low
                endm

                restore
                endif                   ; __stm8sadc2inc